I recently swapped and L86/8L90 into a 84 C10. The motor and tranny are running and I'm trying to finish up wiring my Dakota Digital gauges. I purchased their AFR BIM module (13-2) dakotadigital.com/pdf/BIM-13-2.pdf and purchased an AEM inline wideband 30-0310 30-0310 X-Series UEGO Inline (menlosecurity.com). The DD BIM uses a 0-5 serial input and I have that wired and working correctly. My question is how can I data-log using the MPVI3 with ProLink while still having my gauges connected? Can I piggyback off of the 5V input into the DD module (white wire)? Or can I use the AEMnet to connect to the ProLink? Thanks in advance!