Pro Link analog inputs not recording in Chart vs Time

[Deadhooker]

I have installed Pro Link/Pro Features for the MPVI2. I am using the 2 analog inputs to log 2 pressure sensors. I am able to see these 2 inputs in the Channels window, and they display data correctly. I can add the two channels to the Chart vs Time window but they don't display any data there.

Any suggestions?

[Jay@HAP]

Do you have the correct unit of measurement in the Chart vs Time for whatever you are logging.

What I mean is lets say you are logging STFT, you have to select the unit as % to get it to show up.

If you are logging Lambda for example, the unit needs to be Lambda not AFR.

I hope some of this makes sense.

[yanick]

have you figure out? I got the same issue right now.

[yanick]

I figured out.
the air fuel ratio for my wb don't read anything, until I used equivalence ratio. But now the issue was my commanded is only in AFR.
I used math - user -to convert commanded AFR to lambda
-for the MAF calibration formula
Attachment 146141Attachment 146142Attachment 146143Attachment 146144Attachment 146145