Can someone please explain this? How can I add slightly more fuel.. After startup, the car runs a tad bit on the lean side.
Also.. Since I have a cam that causes the MAP values to be a little "twitchy", should I adjust the delta map for transient fueling enable? I bumped it up from 1.5 to 2.0.
I also have adjusted Evap factor:
X * 1.01 in cells 20-50, X * 1.007 in cell 60, and X * 1.005 in cells 70-100.
And the Impact factor:
X * .98 in cells 20-50, X * .99 in 60, X * .995 in 70-100.
I am getting a very rich dip after I tip into the throttle and let off. This also holds true for when the converter locks up. Should I have adjusted the Accel/Decel ratio as well?
Last question: Is transient fueling working off the Primary VE? Suppose a cam was installed without dialing down the VE in the lower rpm range, would this look like transient fueling was "off" in that range? FWIW, I am running MAF only.